Vehicle body suspended from an overhead conveyor hanger on an automotive assembly line.

SPM HD detects hanger support wheel damage on an automotive final assembly line

Using Intellinova Parallel EN continuous condition monitoring with SPM HD, damage to the plastic coating of an overhead conveyor support wheel was detected at an automotive plant in South Africa. Early identification enabled a planned wheel replacement before functional failure, reducing the risk of an unplanned production stop.

Application and monitoring setup

The application involves plastic-coated support wheels on overhead conveyor hangers transporting vehicle bodies through a final assembly line. Operating at 0-14 rpm with frequent stops and starts, the wheels present a challenging monitoring application, further complicated by the damping properties of the plastic coating.

For a proof of concept, a four-channel Intellinova Parallel EN system was installed with DuoTech accelerometers on one driven and one non-driven support wheel. An existing RPM probe supplied the speed signal.

Results and benefits

SPM HD revealed elevated HDm levels and repetitive impacts within each revolution of the non-driven wheel. The conventional vibration techniques evaluated during the proof of concept provided no clear indication of the coating damage.

The wheel was replaced during a planned maintenance shutdown, and inspection confirmed missing sections of the plastic coating. After replacement, HDm returned to the normal level observed on the undamaged driven wheel.

Taking one hanger out of operation reduces the plant’s output by approximately 5%. Early detection supported planned maintenance and helped protect production capacity by reducing the risk of an unplanned conveyor stop.

Download document

No downloads